Paralleling Gen-set Controllers Training 

Paralleling Gen-set Controllers Training - Complex Controllers and Applications

The course targets on InteliGen NT and InteliSys NT controllers. Participants are expected to have a basic knowledge of gensets and power distribution systems. No previous knowledge of ComAp products is required.

After finishing this training, you will know which ComAp product to choose for your application, where to get detailed information about using the device and how to configure the controller. Further to this, you will also gain knowledge of extending controller capabilities using ComAp controller accessories, including information about remote monitoring and control systems. The training contains several practical sessions where you will be working directly with ComAp controllers.

Note: Standard A and Standard B can be combined; Standard B always follows Standard A.

 

Cost per attendee is 55€ per day.

Training will include:

Training

Arrival in Prague
Our hands-on training takes place at our modern training facility in our Prague headquarters.

Preparation

Basic Information
As a condition for confirmation of your registration, it is required to pay a 55 EUR per day of training administrative fee on our ComAp account, at least 6 weeks prior to the scheduled date of the training course. More information you will find in the email after your registration. 

We are ready to help you with booking a hotel and obtaining a visa. For more information about our corporate rates in nearby hotels and hotel booking please contact us. You can also check the List of countries with visa requirements.

Training

Day 1
9:00 - 11: 45 Paralleling genset applications & controllers overview
ComAp technical support and website introduction, general overview of paralleling applications, documentation, controllers and possibilities of extending their functionality.

11:45 - 12:30 Lunch

12:30 - 15:45 Configuration​
Detail introduction of monitoring and configuration tools - InteliMonitor, GenConfig and WinScope. Controller software management - Firmware, Archive. Hands-on training with a paralleling genset controller on the genset simulator.
Introduction of advanced functions and PLC editor.
Day 2
9:00 - 12:00 Communications
Internal and external communication modules (InternetBridge NT, I-LB+), supported communication protocols. AirGate, WebServer, ECU. Hands-on training on MODBUS RTU/TCP, IB-COM module.

12:00 - 12:45 Lunch

12:45 - 15:15 Commissioning & WebSupervisor Pro
Commissioning and its important steps, checks before engine start, first start conditions (using Winscope), voltage and speed regulation, synchronization process,           gensets paralleling, power management.
Websupervisor (PRO features): dashboard, groups and basic SCADA, data log versus reports.

15:15 - 15:45 Test, Feedback
 

Departure

Stay in touch
Have a safe journey and stay in touch with our training team at training@comap-control.com
Our website uses cookies to provide you the best experience and understand how you use our site. By continuing using this website you are agreeing to the Cookies Policy. You can learn more here.